

VAT on real estate – light at the end of the tunnel
10.08.2015
After much delay, the General Financial Directorate (“GFD”) has finally published its long-awaited information on the application of the VAT Act to real estate after 1 January 2015 (“Information”). Given its unsystematic (hopefully temporarily) regulation, this area of VAT has been full of ambiguities and contradictory interpretations. Therefore the GFD’s representatives promised to issue explanatory information on these issues. The Information explains the interpretation given by the GFD that should also be observed by tax administrators. The details are presented below.
The Information specifies the GFD’s interpretation regarding the following contentious issues or issues subject to no regulation.
Structures
The Information distinguishes between the term “a structure permanently attached to the ground” (a broader term) and “a structure attached to the ground with a firm foundation” (a narrower term, such as with concrete foundations). The use of the terms in relevant provisions (Sections 48, 49, 56 and 56a of the VAT Act) is not uniform. Therefore, attention must be paid as to which term is suitable for a particular situation.Residential structures
There is no change in the definition of residential structures that came into effect from 1 January 2015. The term “residential unit” (byt in Czech) has been replaced by the term “residential space”, whose technical arrangement and fixtures and fittings meet the requirements for permanent housing (what was considered a residential unit by the end of 2014 continues to be a residential space in 2015).Floor area of residential premises for social housing
According to the GFD, since 1 January 2015 the method of calculating the floor area of residential premises has been based on Government Decree No. 366/2013 Sb. The floor area includes:- the area within the inside perimeter of the exterior walls of the residential unit, including
- the floor area covered with fixtures (wardrobes, bathtubs and other fixtures), including
- the ground area of all vertical load-bearing and non-load bearing structures inside the residential unit (walls, columns, piers and chimneys).
- the floor area of balconies, terraces, loggias, and
- the area of rooms used along with the residential premises located in the same building (cellar, storeroom, garage outside the residential premises but inside the same house)
Floor area of a family house for social housing
The floor area of family houses is determined in the same manner as in the previous years as Government Decree No. 366/2013 Sb. can be applied to residential units only, according to the GFD. The floor area of a family house includes:- the sum of the floor areas (inside wear layer) of all rooms in the family house (including hallway, study, and garage located in the house).
- the sum of the floor areas of premises that are not a room (balconies, terraces, loggias, and lofts) and
- the sum of the floor areas of rooms that comprise “outbuildings” of the family house (a garage outside the house).